325 days ago
by teenagewoodworker |
9 comments »
well I’m sure that many off you have had problems with your table saw fence before. and i have been having a lot of problems with mine so i decided to head to Lowes and purchase a delta T-2 table saw fence. i had to go to 3 of them before i actually found it. and it is a big box. it is a pretty beefy fence.
so first i started by removing my old table saw fence and my router table. just to make the installation a bit easier.
then i attached the rails to the table saw. lucki...
Read this entry »
722 days ago
by Blake |
8 comments »
I don’t know if anybody has a Vega table saw fence out there… I got mine used and really like it. It is not one of the big names for after-market fences but it is a good, accurate T-square style fence.
It’s only design problem is that to tighten it you push the front knob down, (like most fences) but on the Vega this motion would tend to lift the rear end of the fence off of the table. Vega’s solution to this was to attach a clip on the back of the fence which reach...
Read this entry »