This end result is a nice little side table, but I must confess, it is not up to my standards. It will make a nice table along side the couch. I’m finishing in haste to get the subscription to PW, but I will continue my challenge and improve this table more at a later date. My son (age 3) loves to hang out in the woodshop, so he can help me. Bottom line, the baby girl goes to the doctor on time, I get my challenge finished, and my son gets to help me finish it next week! Legs, si...
I trusted that the bit for my pocket hole jig was correctly set. I was wrong. When I attached the top to the sides and legs, here is the result. I like the way the table looks, but the holes on top are enough to make me pull out my dwindling hairs. As a result, I had to resort to nailing the top to the legs in order to finish the contest and take my little angel to the doctor.UGH! The smaller holes are from the brad nailer.
The Thorsen House Side Table project is finally finished. The goal of this Challenge was to motivate new expression of the traditional table and to find other ways to interpret the work. I have benefited from this challenge by enhancing my knowledge of the Greene & Greene style. I have read more about their work in the last few months than I have over the past ten years. I found other ways to incorporate the Greene & Greene style in my interpretation and perspective of the Tho...
Ok, Here’s the deal. Its 12:35pm. My daughter has a doctors appt at 3:45. I have procrastinated my challenge project to the point that I had to abandon my idealistic goal of glueless wedge tenons. I do reserve the right to rechallenge myself at a later date on that joint. I will get it done!The legs are clamped up and nearly dry Here's the top. Pocket holes have replaced wedge tenons...Yes, I'm in a hurry. The sides are small, but mighty!
psych, OK, it’s an OLD D.R.BARTON cooper’s side axe/hatchet. I have been looking for a bigger better heavier side hatchet for hewing furniture parts. this may be too big but I’ma gonna give it a try.bought from jimbodetools.comas delivered: and after @ 1/2 hour grinding, and after another half hour, razor sharp and ready for me to try out.
- My Journey As A Scroll Saw Pattern Designer - 1558 parts
- Extremely Average - 324 parts
- Workshop Development - 107 parts
- Just for Fun... - 96 parts
- A journey into the workshop. - 89 parts
- Daily Update - 87 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- As The Lathe Turns - 76 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- ScrollSaw Information and Resources - 68 parts
- Sheila Landry (scrollgirl) - 1583 entries
- frank - 417 entries
- degoose - 395 entries
- dbhost - 390 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- Karson - 305 entries
- Martin Sojka - 296 entries
- mafe - 275 entries
- William - 258 entries
- Betsy - 221 entries
- Stevinmarin - 212 entries
- shipwright - 212 entries
- Gary Fixler - 204 entries
- Todd A. Clippinger - 199 entries
- stefang - 188 entries
- Rustic - 188 entries
- Chris Davis - 183 entries
- BritBoxmaker - 181 entries
- Smitty_Cabinetshop - 175 entries