Woodworking blog entries tagged with 'segmented bowl'

  • Advertise with us
View OSU55's profile (online now)

Turning #1: Segmented Bowl Process

04-07-2015 09:38 PM by OSU55 | 6 comments »

This tutorial is about the process I use to create a segmented bowl, or about any segmented turning item. After researching many methods and trying many of them, I’ve been able to put together a fairly simple and robust process that uses as few specialty tools or jigs as I could. Where possible I used existing jigs and tools that I already had and others may also have. #1 – Design Once you have the approximate size, shape, and feature designs of the end item to build, the number of ring...

Read this entry »

View lew's profile

Segmented Bowl Clamping Jig

07-03-2013 05:11 PM by lew | 28 comments »

After turning a bowl recently from a solid chunk of log, I thought it might be interesting to try my hand at a segmented bowl. After researching the procedures, I figured I better start with a clamping system to glue the stacked rings. There are a wide variety of clamping devices listed on the various turning sites but they are all discrete units. In my little shop, there just is not any more room for an additional piece. I am at the point where when something comes in- something else has to ...

Read this entry »

View TheDane's profile

Segmented Stave Bowl #4: Day Four - At Last!

01-10-2013 11:58 PM by TheDane | 5 comments »

The glued up blank and bottom sat in the clamp overnight and we are ready to turn. I used my carbide R2 cutter to rough out the inside of the bowl. I switched to a bowl gouge to clean up the inside and sanded it with my self-powered sander. I used the carbide to rough the outside of the bowl, a bowl gouge to get it to final dimension, and sanded it while it was still mounted on the scroll chuck. Next, out came the Longworth Chuck to shape and finish the bottom of the bowl. I cut a...

Read this entry »

View TheDane's profile

Segmented Stave Bowl #3: Day Three - Finally Turning

01-09-2013 10:35 PM by TheDane | 2 comments »

The blank dried overnight, so it is time to pull the tape off, install the Cole Jaws on my chuck, and mount the glued-up blank. After tooling off the end of the blank (full disclosure: I use used a carbide R2 cutter to get the end of the blank close to flat), I used a piece of plywood with adhesive back sandpaper to true it up. Next, I cut a mortise in the end of the blank to accept a tenon on the bottom. This mortise is a proud 3/16” deep. The bottom of the mortise needs to be as...

Read this entry »

View BrentH's profile

This is No Bull!

07-31-2015 04:33 PM by BrentH | 6 comments »

No Bull! —My neighbor was pretty impressed when I told him I’d entered a bowl in the County Fair—until he realized it wasn’t spelled “B-U-L-L”. Still, I did all right. I think the prize money is $5. I’ve always told my wife that someday my woodworking would pay off! (Original details of this project were posted on 7/22/15.)

Read this entry »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics