LumberJocks

Woodworking blog entries tagged with 'second generation'

  • Advertise with us
View degoose's profile

Next Generation Cheese boards... #10: The teaser...

12-10-2011 03:54 AM by degoose | 21 comments »

From the last post you would have seen the teaser…Here it is all glued up and marked for cutting into an oval… I also used a little turpentine to enhance the colour and grain…I think the choice of Queensland Red Cedar [toona australis] certainly brings out the angularity of the design…

Read this entry »


View degoose's profile

Next Generation Cheese boards... #1: Make a start...

11-05-2011 10:28 PM by degoose | 18 comments »

Today, as I make my way out to the workshop, ideas are flying around… having looked at the information on lamination design that Scott sent….wow… so many new thoughts are spinning through my head… I had an inkling as to how it was done… but now the technical part is explained… So, to the shed…..rip, glue, crosscut, glue, crosscut at a different angle and glue again… then sand, sand, and sand some more… These three boards were made us...

Read this entry »


View degoose's profile

Next Generation Cheese boards... #3: Cutting for the second time...

11-07-2011 01:02 AM by degoose | 16 comments »

Out of the clamps… and cut at 25 degrees… [through the centre of each chevron going down from left to right…] each other piece rotated end for end… For those who can not picture this… there will be a video forthcoming.. by the end of the week I hope… And now back in clamps for the day… out tomorrow and I will see if this goes to the third gen… Stay tuned…By the way… timbers used Queensland Maple and Purple Heart…

Read this entry »


View degoose's profile

Next Generation Cheese boards... #5: Step by step...

11-12-2011 12:43 AM by degoose | 11 comments »

This post documents the step by step in creating a 2nd generation board.. Striped board… cut at 50 degrees. Flip every second piece left to right… After glueing up the chevron pattern… cut through each down facing [right to left] stripe… at the centre at 25 degrees… Now flip every other piece end for end and glue up again… Now cut to shape… In this case the one on the right…

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase