I sold my old lumber storage solution which was… inelegant, to put it lightly. I am purposely storing this set of lumber outside, half because I ran out of room in my indoor storage, but also to have a bit of weathered wood handy, should the need arise. I went simple with this, using some pallet runners, I bored some holes at a slight angle ever so slightly undersized for the conduit pieces I had prepared as shelf supports. I then attached the wood brackets to the wall and hammered in...
I’m going to do a half lap with a cross cut, chisel paring, and followed through with a shoulder plane. Now if you didn’t know better, you might be thinking I’m an Olympic diver getting ready to execute a stunning high dive. But alas, I am not. I’m a woodworker, and this is a structural joint and the tools I will use to make a simple, yet strong woodworking joint. The Half Lap is a joint used to connect two intersecting pieces of wood. Each piece of wood is sawn to half its thickness. Whe...
Since I did a video how to fit inset doors, I thought maybe I should take a step backwards and show how to make a simple cope and stick cabinet door. Hope you enjoy the video, especially the ending.:-)
Here’s a great tip on using up those scrap pieces of plywood. If you like this video, we have new ones every Thurdays on our youtube channel.
OK, I just updated my Dovetails plugin video, and had it relinked on my other post. since I don’t want this post to be a plug for my plugin (dope) I’m not going to link to it here, if you are so inclined, I’m sure you can find it. now that we have that out of the day, the following is the updated video, which although focuses on the simplicity and efficiency of the dovetails plugin, also carries with it some other neat capabilities of SketchUp which I use all the time ...
On July 3rd I threw together a chair to bring to the 4th party the following day. I decided to use up some scrap 2×4s. I had no plan, no chair experience, and about 5 hours time in which to make it, so I just sort of winged-it, inventing as I went. Here’s the test-fit of the cut pieces for which I used my miter saw and band saw. It looked somewhat chair-like, at least. I used countersunk deck screws and glue. I banged pieces around in the clamps to get everything exac...
- My Journey As A Creative Designer - Woodworking and Beyond - 1742 parts
- Extremely Average - 324 parts
- A journey into the workshop. - 107 parts
- Workshop Development - 107 parts
- Just for Fun... - 97 parts
- Daily Update - 87 parts
- Life as an Amateur Woodworker - 79 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- As The Lathe Turns - 76 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- Sheila Landry (scrollgirl) - 1767 entries
- dbhost - 420 entries
- frank - 417 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- Karson - 305 entries
- mafe - 304 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 246 entries
- Betsy - 228 entries
- stefang - 220 entries
- robscastle - 218 entries
- Dave Rutan - 214 entries
- Stevinmarin - 212 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 194 entries
- A Slice of Wood Workshop - 190 entries