I recently went digging through my late Grandfather’s garage and found a practically new Craftsman 1 1/2hp router with the box, but no instructions. I decided to buy a small router table at a local box store knowing it wasn’t anything great but just something to try my hand at for the time being. I finally got around to using it today. I’m finally finishing the cabinet doors I’ve been putting off for months, and decided to route the dadoes using the table. For some rea...
Hello everyone…... its that time to wipe the thick layer of dust from my shelves, drawers and tools. i do this at least once a month. during that time i blow all the dust out of the shop with my leaf blower. i take all of my important tools apart and replace brushes, belts, bits and blades. i oil, grease and lubricate all moving parts and bearings. the tool that i pay most attention to in the shop is my 10” cabinet saw. i am constantly checking to see if the blade is square to the...
I have a Laguna NLX31 combination machine with table saw, jointer/planer, and shaper.The table saw motor works great but the jointer and shaper motors are running slowly maybe something like half speed. I have had the motor and capacitors checked, the 40uF and a 50uF capacitors were within uF tolerance, but I have since replaced with with new. That did not fix the problem. The table saw starts even faster now, but the same problem exists with the other two motors. I unhooked the belts...
Hello everyone, i’m really hoping someone can shed some light on this problem for me. I have an older craftsman Jointer/Planer that is in great working condition, however it has one major problem. Even though the infeed and outfeed tables are parallel when i push a board through it raises up off the outfeed table. Hopefully the pictures below will help…... To me the table look very parallel weather the depth is set to 1/8” or zero. Now time to put a board...
I am trying out a new video feed. The service I was using before and have been using for years just kept adding ads and then got to the point to where they’d put a commercial on the videos and the feed at start-up. Most of the commercials I didn’t like. I felt they were inappropriate. One car company ad kept using foul language, even though it was being bleeped It was still known what was there. I even tried to trick the system into using more kid friendly ads by putting ta...
- My Journey As A Creative Designer - Woodworking and Beyond - 1742 parts
- Extremely Average - 324 parts
- Workshop Development - 107 parts
- A journey into the workshop. - 106 parts
- Just for Fun... - 97 parts
- Daily Update - 87 parts
- Life as an Amateur Woodworker - 79 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- As The Lathe Turns - 76 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- Sheila Landry (scrollgirl) - 1767 entries
- dbhost - 419 entries
- frank - 417 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- Karson - 305 entries
- mafe - 304 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 246 entries
- Betsy - 228 entries
- stefang - 220 entries
- robscastle - 218 entries
- Dave Rutan - 214 entries
- Stevinmarin - 212 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 194 entries
- A Slice of Wood Workshop - 190 entries