LumberJocks

Woodworking blog entries tagged with 'problems'

  • Advertise with us
View Kim's profile

Laguna NLX31 #1: Problem with Motors

09-03-2013 08:09 AM by Kim | 7 comments »

I have a Laguna NLX31 combination machine with table saw, jointer/planer, and shaper.The table saw motor works great but the jointer and shaper motors are running slowly maybe something like half speed. I have had the motor and capacitors checked, the 40uF and a 50uF capacitors were within uF tolerance, but I have since replaced with with new. That did not fix the problem. The table saw starts even faster now, but the same problem exists with the other two motors. I unhooked the belts...

Read this entry »


View John_G's profile

3 Girls & A Woodworker #9: Jointer Problems, HELP PLZZZ

07-12-2011 10:08 PM by John_G | 22 comments »

Hello everyone, i’m really hoping someone can shed some light on this problem for me. I have an older craftsman Jointer/Planer that is in great working condition, however it has one major problem. Even though the infeed and outfeed tables are parallel when i push a board through it raises up off the outfeed table. Hopefully the pictures below will help…... To me the table look very parallel weather the depth is set to 1/8” or zero. Now time to put a board...

Read this entry »


View Chris Davis's profile

New video feed

01-13-2011 05:13 PM by Chris Davis | 9 comments »

I am trying out a new video feed. The service I was using before and have been using for years just kept adding ads and then got to the point to where they’d put a commercial on the videos and the feed at start-up. Most of the commercials I didn’t like. I felt they were inappropriate. One car company ad kept using foul language, even though it was being bleeped It was still known what was there. I even tried to trick the system into using more kid friendly ads by putting ta...

Read this entry »


View Jim's profile

Lessons... #1: Inheriting Tools

04-21-2009 11:30 PM by Jim | 13 comments »

I recently went digging through my late Grandfather’s garage and found a practically new Craftsman 1 1/2hp router with the box, but no instructions. I decided to buy a small router table at a local box store knowing it wasn’t anything great but just something to try my hand at for the time being. I finally got around to using it today. I’m finally finishing the cabinet doors I’ve been putting off for months, and decided to route the dadoes using the table. For some rea...

Read this entry »


View Mike Shea's profile

need HELP from the tool junkies

01-26-2009 05:12 AM by Mike Shea | 15 comments »

Hello everyone…... its that time to wipe the thick layer of dust from my shelves, drawers and tools. i do this at least once a month. during that time i blow all the dust out of the shop with my leaf blower. i take all of my important tools apart and replace brushes, belts, bits and blades. i oil, grease and lubricate all moving parts and bearings. the tool that i pay most attention to in the shop is my 10” cabinet saw. i am constantly checking to see if the blade is square to the...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase