LumberJocks

Woodworking blog entries tagged with 'link belt'

  • Advertise with us
View Robin1's profile

Table saw restoration #1: New (to me) Craftsman Table Saw - edited photos and text

11-23-2016 01:54 PM by Robin1 | 12 comments »

Thanks to Knotscott, who lives close by, I found a craftsman in very good shape. I’ve upgraded the belt with a link belt from Harbor Freight (good deal) and the fence with a Vega Pro 40. Just need to get the other wing on, add an extension table and ZCI and do something about the switch. Works great though! (Any advice on the switch would be appreciated. The original set-up had the motor plugging into the switch and the switch plugging into the wall. I’m assuming I’ll ha...

Read this entry »


View Sawdustonmyshoulder's profile

Delta 46-715 Lathe Refurbish Project #7: Controls Done and Turning Zinc!!

01-20-2015 04:02 AM by Sawdustonmyshoulder | 14 comments »

The control box is done and mounted. I found a few things out the hard way. One was you don’t ground the motor controller. Man, the flash and the smoke! Well, that was a motor controller down the drain. Luckily, I had a spare. Upon a little research, DON’T GROUND THE MOTOR CONTROLLER’S HEAT SINK. The box I bought was aluminum, so I had to isolate the motor controller from the box. Nylon screws, washers and bolts was the solution to the grounding issue. I did ground the alumi...

Read this entry »


View Sawdustonmyshoulder's profile

Delta 46-715 Lathe Refurbish Project #5: Motor Mount and Indexing Pulley

01-11-2015 01:32 AM by Sawdustonmyshoulder | 1 comment »

Today was a good day. Received the indexing pulley from Fred Borden in the mail. Thanks, Fred. Installed it on the lathe and it works great. May need to be turned and trued up a bit. It must have had a hard life. No problem to do it. A friend needed a treadmill to be disposed of and wouldn’t you know it, it had a motor mount that I could use. After cutting the motor mount off the frame with a grinder, I put it on the motor and Shazam… it works perfect. I need to get a belt f...

Read this entry »


View FreezFurn's profile

Jet JBS-18 Bandsaw Restoration #2: Getting the Jet BS Up and Running

08-27-2013 02:48 AM by FreezFurn | 0 comments »

It took me quite some time to get 240v ran to the basement, but the installation of a new gas stove right above me in the kitchen could not have been better timed. So, I extended the line from the stove and added two new outlets in the ceiling of my shop. I did not want to invest too much money into a lemon, so I hesitantly hooked it up to the new wiring. It cranked up and ran very loudly with no blade. Which brings me to bearings. Here is a pic of the old upper wheel bearings. They were...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com