Gluing up was quite an interesting time with so many pieces to go together at once. I did the ends first then dry fitted everything to make sure all of the joints would fit up square prior to adding the glue and clamping (using the offcuts from the legs when clamping) I have added one coat of Danish Oil but need to get the lid on before I can finish the handles and add finish to them.
Hey Steve, this post is in response to your comment on my last post in this series…Even though the new CNC router is not yet installed in my workshop, I managed to take my first foray into the dark side… I spent the day at the factory where my CNC is being built… it is all up and running… just a few minor adjustments… Justin will deliver on Wednesday and spend the day making sure I am happy with the machine. So .. with a little piece of Huon Pine clamped...
No explanation required… just watch.. Here is the dry fit after all the pieces have been cut… I did not show the cutting of the background Huon Pine peices .. I figure you know how this was done…. all cut at the first stop.. and again keeping them in order for grain flow…
Here you will see the steps in the glue up of the weave strips… The strips are ready for assembly.. After applying glue to the various surfaces, I assemble the 5 pieces in order and secure with blue painters tape.. this is easy to remove later… While just using tape can be enough, I like to clamp between two cauls to ensure that the width of the piece remains constant along the entire length.. and it aids by applying even pressure on the strips being glued..As each set is...
I am about to make an open weave Lazy Larry…similar to this one. I have ripped some Tasmanian Blackwood into the required strips….. these are just over 600 mm long and 50 mm by 20 mm For our American cousins… 2 feet long and 2 inch by 3/4 inch.. Tomorrow I will be ripping some thin stripes of Huon Pine and Tasmanian Blackwood to make the accents… Strips will be only 3 mm thick [ 1/8 inch] The background will be Huon Pine….. cut into 50 mm squares̷...
Huon Pine has an interesting history in Australia. At one time it was used to make the crates for apples to be transported. A native timber of Tasmania (the island bit on the bottom of Australia) it is now highly sought after as a cabinet making timber. Despite this, looking through images on the net I have seen wooden sailing boats made from this timber, recently. My understanding of the current situation is that no trees are allowed to be felled, except in exceptional circumstances. ...
- My Journey As A Creative Designer - Woodworking and Beyond - 1792 parts
- Extremely Average - 324 parts
- Toy costruction - 115 parts
- A journey into the workshop. - 110 parts
- Workshop Development - 107 parts
- Just for Fun... - 98 parts
- Daily Update - 87 parts
- Life as an Amateur Woodworker - 81 parts
- Woodworking on a Half-Shoestring - 81 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- Sheila Landry (scrollgirl) - 1817 entries
- dbhost - 436 entries
- frank - 417 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- mafe - 313 entries
- Karson - 305 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 254 entries
- robscastle - 241 entries
- Dave Rutan - 231 entries
- Betsy - 228 entries
- stefang - 221 entries
- Stevinmarin - 212 entries
- A Slice of Wood Workshop - 210 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 195 entries