Sometimes things break. This is one of those cases. There was probably a defect in the wood that was undetectable when I built the chair and when the wrong set of forces were applied to the chair, one of the two legs broke after the joint. To fix the chair, I built a sled that would ride on the table saw and support the chair standing up and would allow me to use a spacer block, after the first cut to create a new mortise for the bridal joint. Here is the chair in the sled. Noti...
So one of the other projects I wish to accomplish this year (towards spring/summer) is a foot powered grinding wheel. gives you a vague idea of what I’m going after. The image, btw is from http://autonopedia.org/crafts_and_technology/Wood/Wood_Harvesting_with_Hand_Tools.html which might be of some interest to others. So the main choice facing me is natural stone, either harvested around me or from a stone yard, or to make a wheel using concrete/abrasive sands, several recipes ...
Right hand sideLeft hand sideThe underside I not certain that this qualifies for a “project” but it’s been raining here for the last two days (on vacation not withstanding!) so I had to do something. The base started from a 12×12 blank of 1/8” hardboard and trimmed down to final size of 12×11-1/16. I made the base a lot wider on the left hand side so that I can use the saw with my good hand (left hand). The way is was before, the motor would hit the c...
Hi all; I always mention my buddy Bruce, and here’s a post dedicated to him, (even though he’s still alive) knock on wood. He has no experience in wood carving, other to set a hinge or something. When we were building the Philadelphia Pie Crust Table, he would work on parts like turning the post, laying out the pattern for the top, as well as cutting it out and hollowing the middle of it with a router. The 1 inch thick board becomes about 5/8 inch in the middle are...
This is the jig that really should have been the first of the series. I have to lay out the story a bit. Let’s just say that I am 3-D challenged. I started off to make a batch of mitered feet for jewelry boxes. I used the table saw and jointer to make a long strip of wood with a 45° chamfer on one edge, about 36” long x 3” wide x .5” thick. I laid out the edge opposite the chamfer with an approximate 30° taper, each foot section about three inches long. Having cut each...
- My Journey As A Creative Designer - Woodworking and Beyond - 1742 parts
- Extremely Average - 324 parts
- A journey into the workshop. - 107 parts
- Workshop Development - 107 parts
- Just for Fun... - 97 parts
- Daily Update - 87 parts
- Life as an Amateur Woodworker - 80 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- As The Lathe Turns - 76 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- Sheila Landry (scrollgirl) - 1767 entries
- dbhost - 420 entries
- frank - 417 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- Karson - 305 entries
- mafe - 304 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 246 entries
- Betsy - 228 entries
- stefang - 220 entries
- robscastle - 218 entries
- Dave Rutan - 214 entries
- Stevinmarin - 212 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 194 entries
- A Slice of Wood Workshop - 190 entries