First mortise/tenon #1: Practice mortise and tenon joint
Well, After making a small jig for my drill press and a small simple sled for my table saw I have produced my first mortise and tenon joint using a couple of pieces of scrap pine. I drilled the mortise and cut the tenon on my TS then cleaned up both with a chisel. Not too bad for a first try I think. It is snug. I need to get a new blad for my table saw. I think it bends a little bit. It is an inexpensive blade and thin. Anyone else think that this can cause issues? I think I’d get a st...
