Ah the pith. That very core of the tree, that for some reason, is remarkably unstable in use as lumber. The inclusion of the pith in some of the beams I have obtained all but ruins an otherwise solid thick chunk of wood. It really pithes me off. All kidding aside. I can probably still make some good use out of these beams, even the ones with the pith in them, with some thought into my cuts. I was contacted last week by an old woodworking acquaintance, Maxwell. He told me he saw my b...
This week life intervened and I didn’t get much work done on the bench. Just before I left on my trip I started to drill the holes in the side rails. I started by using a 3/4” auger bit in my drill press. Unfortunately I didn’t plan this step quite as thoroughly as I have done for the rest of this project. Mistake #1 not trying this technique on a pice of scrap first and instead drilling into the bottom rail of the workbench. Mistake #2: Not clamping the rail down to the ta...
Had a rough for for a couple months will little time in the shop. Some for obvious reasons, the rest mostly due to work. I know my voice has been out there in the forums, but the majority of the posts are done from my work computer as adverse to the home computer. I finished flattening the top of the bench and added dog holes for the hold fasts and the bench dogs. The top has been especially challenging due to the space in my shop. I don’t like working in tight spaces. I have about a...
Hello. I have just finished joining and glueing up the two doghole strips and the top slab. First I milled the 8 3/8” wide slab top to length by crosscutting it roughly and using a router with a straight bit and straight edge to square it up nicely. With the two doghole strips I crosscut them on the table saw. I was impressed to find the saw made an almost perfect finish on the endgrain. I then marked where the threaded rod will go and marked out the position of the dog holes which a...
I have finally achieved a new level of not getting into my shop. The Dust Troll under my bench just asked for ID, it’s been so long since I spent any time (other than a pass through to the garage door). I have a couple of weeks off from the job that pays for the fun I am supposed to be having in my elusive man-cave so I plan to get things moving. All joking aside, I have managed to do the following since June: turned my Rigid 14” bandsaw into Frankensaw with Kreg & Car...
- My Journey As A Scroll Saw Pattern Designer - 1038 parts
- Extremely Average - 325 parts
- Daily Update - 87 parts
- A journey into the workshop. - 85 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- Just for Fun... - 72 parts
- The Craftsman's Path - 67 parts
- Workshop Development - 64 parts
- 52 Weeks - 52 parts
- Sheila Landry (scrollgirl) - 1060 entries
- frank - 417 entries
- degoose - 384 entries
- Ecocandle - 326 entries
- dbhost - 318 entries
- Martin Sojka - 294 entries
- Karson - 288 entries
- MsDebbieP - 283 entries
- Betsy - 221 entries
- William - 210 entries
- Gary Fixler - 204 entries
- Stevinmarin - 197 entries
- mafe - 186 entries
- Chris Davis - 183 entries
- Todd A. Clippinger - 182 entries
- Rustic - 182 entries
- PurpLev - 159 entries
- BritBoxmaker - 146 entries
- scottb - 144 entries
- kosta - 144 entries