LumberJocks

Woodworking blog entries tagged with 'crisscross'

  • Advertise with us
View Mark Kornell's profile

Workbench Build #16: Leg Vise Install

12-11-2014 07:02 AM by Mark Kornell | 5 comments »

If figured it would be better to work on the vise install on the leg before the bench was assembled. Heeding my own advise, I read and re-read the install instructions again before I started. First thing I realized was that the leg vise install is as much about the chop as it is about the leg. Makes sense – a vise isn’t much with just one surface :-) So I glued up a board to use as the chop: The chop needs to be at least 2 1/2” thick and I all have is 8/4” board...

Read this entry »


View Dave's profile

Roubo Workbench #4: Ch3 - Crossed Up

07-11-2014 07:13 PM by Dave | 0 comments »

After the success tweaking the installation for the end vise I hoped the good karma would continue to the leg vise. Not so… It All Starts With A Small Bonk… I removed my chop from the clamps, removed the glue and jointed/planed to size. the final size was about a 2 3/8 thick – plenty. I determined the centerline of the chop and leg and clamped the chop directly to the leg. I transferred the hole locations to the chop. The it was off to the drill press. Simple. While at Marc Adam...

Read this entry »


View CL810's profile

Crisscross, David Barron, and Danish Oil walk into a bar... #1: The Crisscross

12-10-2013 11:59 PM by CL810 | 10 comments »

In case you’re stopping here without seeing the project post, here’s my bench. Benchcrafted’s Crisscross has been covered before I’m sure but I’ve only seen one posting about it by Jusfine. So I thought I’d cover a couple of points about it. First, the reasons I went with the Crisscross was I wanted a pinless leg vise to avoid bending over. I know there are other devices that work as well, but this one just suited my eye. For me,the most critical s...

Read this entry »


View jusfine's profile

Roubo Inspired Bench #4: Benchcrafted Hardware installation and a surprise visit

05-25-2013 09:09 PM by jusfine | 5 comments »

Installation of the wagon vise hardware – very easy to follow directions! Gluing up the paduak for the leg vise. If you are going to use the crisscross system, ensure you have a minimum of 2 1/4” final thickness on your vise as the cavity routed for the hardware is considerable. Plywood top is in place and vise hardware is partially assembled. Couldn’t resist trying the hardware out after the right front leg was drilled for the holdfast clamp...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com