783 days ago
by Doodler |
1 comment »
Continuing routing the inlets for the cribbage board…
After using the fence and clamps to route to the edges of the inlets I finish routing out each segement freehand.
I previously scribed the curved segments with a compass and now I carefully cut around the curves with a knife. This is not a common X-Acto which would break immedietly on the ebony, but a hardened steel surgical blade I purchased from Micro-Mark.
I use a micro chisel to clean out the edges of the cur...
Read this entry »
826 days ago
by Doodler |
5 comments »
Well I haven’t been here in a while. Summer is usually slow for cribbage board business and I actually spent two months doing no woodworking at all. First break I’ve had since I started making boards about 4 years ago. I did spend some time improving my shop and putting in a dust-collection system. I’ll update the pictures of it soon.
Anyway I was contacted by a potential customer who liked my newest board design (the paua rosa with maple burl board in my projects page). ...
Read this entry »
