Woodworking blog entries tagged with 'compound angles'

  • Advertise with us
View Donna Menke's profile

DragonFly Harp #6: 1/12/2011

01-12-2011 09:24 PM by Donna Menke | 10 comments »

Doesn’t seem like 6 days have passed, but the calendar does not lie. I have a lot to catch up with.First order of the day was to edge join the pieces I would need to have wider- like for parts of the stand legs and the base of the harp.These Bessey clamps are the best.Then I needed to cut the angled sides. This was the most dreaded job, and the first rip (with the grain) on the table saw (my second least-favorite power tool). Took most of a morning to assemble the tool and then to figur...

Read this entry »

View StLouisWoodworker's profile

The math of compound-angle joinery

09-07-2014 06:09 PM by StLouisWoodworker | 3 comments »

My friend, Bill Gottesman, and I recently finished writing a note about compound-angle joinery. The math behind the equations for setting up the blade and miter-gauge angles for compound-miter and compound-butt joints is developed. Writing it was our way to figure out compound-angle joinery. There may be simpler ways to do that, but this worked for us. Maybe it will for you too. But you have to have a strong stomach for lots of trigonometry. If you do, here is a link to the note, titled ...

Read this entry »

View DustyMark's profile

Building a Thos. Moser Design New Gloucester Rocking Chair #14: Evaluating the Prototype Top Crest

01-03-2013 07:48 PM by DustyMark | 2 comments »

Ready to Cut Final Top Crest? I finished turning the 14 back spindles on the first rocking chair over the past three days. As I finished each spindle, I inserted it into the seat. Once I had the middle four spindles completed, I began inserting them into the top crest as well. The prototype top crest is only 1 1/2” tall. The final top crest is 2 5/8” tall and will be cut from some scraps of 12/4 cherry that I had saved since completing my pencil post bed almost 20 years ago...

Read this entry »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics