09-07-2014 06:09 PM
by StLouisWoodworker |
3 comments »
My friend, Bill Gottesman, and I recently finished writing a note about compound-angle joinery. The math behind the equations for setting up the blade and miter-gauge angles for compound-miter and compound-butt joints is developed. Writing it was our way to figure out compound-angle joinery. There may be simpler ways to do that, but this worked for us. Maybe it will for you too. But you have to have a strong stomach for lots of trigonometry. If you do, here is a link to the note, titled ...
Read this entry »
01-12-2011 09:24 PM
by Donna Menke |
10 comments »
Doesn’t seem like 6 days have passed, but the calendar does not lie. I have a lot to catch up with.First order of the day was to edge join the pieces I would need to have wider- like for parts of the stand legs and the base of the harp.These Bessey clamps are the best.Then I needed to cut the angled sides. This was the most dreaded job, and the first rip (with the grain) on the table saw (my second least-favorite power tool). Took most of a morning to assemble the tool and then to figur...
Read this entry »
01-03-2013 07:48 PM
by DustyMark |
2 comments »
Ready to Cut Final Top Crest?
I finished turning the 14 back spindles on the first rocking chair over the past three days. As I finished each spindle, I inserted it into the seat. Once I had the middle four spindles completed, I began inserting them into the top crest as well. The prototype top crest is only 1 1/2” tall. The final top crest is 2 5/8” tall and will be cut from some scraps of 12/4 cherry that I had saved since completing my pencil post bed almost 20 years ago...
Read this entry »