To view the post with pictures, please click here. Had to start sometime I guess! I didn’t do a whole heck of a lot. More like prep work, I figure. First, I took my 1×6 plank of pine and cut two 36” lengths. The bench is just a hair over 36” tall so the vise will be just off the floor. Next, I drew out the design I wanted. Nothing too fancy, just a slight curve (I drew it without a compass or round object) and a few straight lines. I decided since I will b...
First of all I just want to say that I love the term “sliding deadman”. I think it’s hilarious! As a forensics investigator for the Edmonton Police Service (a city nearing a million in population) I have seen my fair share of dead men, literally. But I have never seen one sliding! Not even in the cold, snowy, icy winters that we have. But I’ll bet that if I do, I will probably bust a gut laughing while thinking about the work holding device on my bench instead of whate...
This project is a fine example of the 80/20 concept. it takes 20% of the project time to complete 80% of it, and then, 80% of the project time to finish the last 20% of the project. As it gets to the details, things take longer to think through, plan out, cut…mill…glue… and finesse. this time it’s the leg vise Chop, and although not completely finished (still need to trim, round off, and apply BLO), it’s construction is done. I was originally planning to us...
Well it was a longtime coming but I have finished the bench. I’ve been having an issue getting the main face vise to operate smoothly. It worked just fine when I had it mocked up, but once I added the final chop it was grabbing and binding. It took some trouble shooting to find the problem, but in the end the problem was me trusting that power tools can do an accurate finish job. More on that later. First I thought the problem was that the new chop was bigger and heavier. I thought th...
When designing the shop I tried to anticipate the type of work we would be doing. Looking back, I wasn’t even close. However, in spite of that, the work flow is very much the same for many woodworking projects. Our shop is laid out considering that work flow. Our entrance door is where we unload both sheet goods and solid lumber. We stack the lumber on stickers, prior to use, and the plywood is placed on a drywall cart. We place lumber on the chop saw station, which ...
- My Journey As A Creative Designer - Woodworking and Beyond - 1793 parts
- Extremely Average - 324 parts
- Toy costruction - 116 parts
- A journey into the workshop. - 110 parts
- Workshop Development - 107 parts
- Just for Fun... - 98 parts
- Daily Update - 87 parts
- Woodworking on a Half-Shoestring - 82 parts
- Life as an Amateur Woodworker - 81 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- Sheila Landry (scrollgirl) - 1818 entries
- dbhost - 436 entries
- frank - 417 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- mafe - 313 entries
- Karson - 305 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 254 entries
- robscastle - 242 entries
- Dave Rutan - 231 entries
- Betsy - 228 entries
- stefang - 221 entries
- Stevinmarin - 212 entries
- A Slice of Wood Workshop - 211 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 195 entries