Here is the latest:The pieces are all made. On to the board. Birds Eye Maple and Rosewood.I got the veneer supplies ready to go and glued each piece to the 1/2” Birch Ply after cutting them to rough width, 2.25”. I used the full length of each 12” piece of veneer and had a gap in the middle, which was fine because I had enough to get the eight strips out of it. Each strip is 24 inches long and I just cut what I needed out of it and skipped over the gap. I then cleaned up the...
I gave up on finishing this checkerboard project in time for Christmas, and then I was out of commission with a bad chest cold for another three weeks. Once I was back to 100%, I got to work finishing my White Oak Bookcase project. Now it’s time I got this one back on track. The last thing I had done on this project was to glue up all the squares for the top. I did half of the board at a time and then used my biscuit joiner to join the two sections together. I put in some time ...
After several hours of carving with my Dremel tool over the last two days, I completed the custom checkers for this project. This was my first attempt at wood carving and with 48 sides to carve, it was a bit tedious, but not too difficult. My skills improved a good deal by day two and I took some extra time to go back over the first day’s checkers and make sure they were all pretty consistent. I took some video of the carving process to post as a separate blog entry once I have...
I got side tracked and didn’t accomplish any of the goals that I set for today. The day wasn’t a total loss though. I made a batch of chili and I watched a few videos on dovetail joints and marked up my boards. I need to clear space on my bench to do the cutting, so that was my excuse for not starting on them until I finish gluing up the top. Out in the garage, I glued up a few more rows and while I was waiting for the glue to dry, I started thinking about the game pieces th...
It was a good day in the garage. I need a few more like this one to keep me on track to finish this project and a few others before Christmas Eve. First I cut the pieces for the base frame, box sides, and the drawer fronts out of White Ash). Because I’m going to attempt dovetail joints for the first time on the box sides, I cut the sides by hand and jointed the edges by hand to make sure they were perfectly matched. My playing surface was about a quarter of an inch ove...
- My Journey As A Creative Designer - Woodworking and Beyond - 1737 parts
- Extremely Average - 324 parts
- Workshop Development - 107 parts
- A journey into the workshop. - 98 parts
- Just for Fun... - 97 parts
- Daily Update - 87 parts
- Life as an Amateur Woodworker - 78 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- As The Lathe Turns - 76 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- Sheila Landry (scrollgirl) - 1762 entries
- frank - 417 entries
- dbhost - 410 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- Karson - 305 entries
- mafe - 303 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 239 entries
- Betsy - 228 entries
- robscastle - 217 entries
- stefang - 215 entries
- Stevinmarin - 212 entries
- Dave Rutan - 210 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 193 entries
- Rustic - 190 entries