LumberJocks

bj383ss's Blog

  • Advertise with us
This blog is written by bj383ss | 23 entries so far

Latest Entry

3D Router #3: Gantry and Y-axis

08-04-2017 11:17 PM by bj383ss | 2 comments »

Work on the gantry and Y axis rails. All the bearings installed and mocked up the gantry to the table. Mounted the rear stops for the Y-axis box. This is the Y-axis box being assembled. Threaded insert in the top of the Y-axis box so it can be lowered up and down on the gantry. Cut and drilled the rails for the Y-axis Installed using some ‘Old School slot screws”. I clocked all of them. Mounting the Y-axis piece to the box. These bottom holes on the gantry where the bottom bearing mounts were suppose to have a +/- 1 mm on the top side. But I ended up needing to have that clearance on the bottom side for mine. Gantry i...

Read this entry »

Older Entries

View all 23 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com