LumberJocks

A little time off #3: Time for a glue up

  • Advertise with us
Blog entry by bandit571 posted 11-04-2017 10:25 PM 275 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 2: Back to work, a box from Poplar scraps Part 3 of A little time off series Part 4: Dovetails cleaned up, lid is done.. »

First, I needed to make a bottom panel, and some grooves to fit the panels ( 2) into…

Dry fit, to get the size of the panel…close.. need grooves, though..

Set up the Stanley 45 with the #13 groove cutter. Built a jig on the bench….so the sides would stay put..

Get one side grooved along both edges, the do the other long side….adjust things to hold the shorter ends..

Made a bunch of “noodles”

Once all 8 grooves were done, I checked how they lined up..

Needed a rebate plane…

Bottom panel needed a rebate all around, as it was a bit too thick for the grooves…adjust the jig again.

Wards (Stanley) #78. Works nicely going across the grain..

Had to keep checking to make sure I didn’t go too deep. As for the edge grain….I started the cuts, but needed a different plane to remove most of the waste..

Then a pass or two to get to the final depth….Dry fit before the Elmer’s?

Then spread the Elmer’s around, and get out the clamps…

And let this sit a day, or so….stay tuned.

-- A Planer? I'M the planer, this is what I use



1 comment so far

View glideking's profile

glideking

33 posts in 34 days


#1 posted 11-05-2017 12:14 AM

I enjoyed thanks!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com