| Blog series by Andy Brownell | updated 911 days ago | 1 part | 965 reads | 2 comments total |
Part 1: Fabrication, Assembly, and Finishing
I cut all of the parts for the bases over the last couple of weeks, mortise and tenoned all of the rails and legs and rails, and assembled the bases. Each table used a custom jig for cutting the tapers on the table saw. My hope is to use these again for another commissioned project. They handle 26 1/4” and 28 1/4” legs. Each taper starts 1” below the edge of the rails, ending to a 7/8” taper at the ends. The sapele really planes well with a sharp low-angle blade....
