Occasional Table for Fundraiser #2: Top, legs and starting the joinery
When I left off before I was just heading out to the shop to start working on this project and was quite excited. Here’s a walk through of what my day off work and in the shop looked like: Starting by jointing and gluing up the panel for the top: It had a slight cup in it after clamping so you can see the C clamp holding the bar from another clamp against the top to keep it flat. I didn’t expect it to work but it did, the top is all but dead flat! Then it was off to tracing out the template onto the legs so I could layout joinery and do the rough cut on the bandsaw. Here you can see the mortises that I cut while the legs were still square. I used a mortising...
