| Blog series by Zuki | updated 1268 days ago | 4 parts | 3486 reads | 22 comments total |
Part 1: Small Steps
A couple of years ago I built a table and chair set for a friend’s two little girls. Well since then they had a little boy and the “Lil Guy” needs a chair. I poked around the shop to try and find the drawings for the set so that I could get some measurements. I found something that looked like kids chairs so off I went. The previous set of chairs had a straight back, but this set I wanted a little rake. So I made this template from some packaged pine I planed down some scrap spr...
Part 2: cutting it short
Did some cutting today. 8 front legs @ 11.5 inches 8 side aprons @ 9 inches 8 front aprons @ 8 inches 8 back rails @ 8 inches I also made a jig for the DP so that I can drill holes to mount the back rails. Next is sanding and assembly
Part 3: 6000 words
Six pictures @ 1000 words each = 6000 words. I just need to attach the seats, plug the holes and a final sanding.
Part 4: Ready to use
I attached the seats to the chairs. Made oodles of plugs and popped them into the rear leg screw holes. When the glue dried I flush cut the plugs, quickly sanded them flush and voila. Four little chairs. Thanks for following.
