Broke out the eggbeater drill, brace with countersink bit, and a screw driver. Marked out my holes with combo square and awl. Drove in some #10 1 1/4 slotted screws by hand, ended up with a blister. .
4 per side per shelf, overkill i believe, planned on only 3 but apparently my subconscious kicked in and made me do 4.
they are all clocked inline with the grain for you ocd individuals (wish i had some Citric acid to remove the zinc plating) I shoulda went with my first idea and countersunk with a bit that i could put a plug in.
So I crosscut the upper front (bra), to width, ripped to rough height with my duo of D8s. Then quick clamped it up in place, marked out the 30 degree bevel continuing it off the sides bevel.
Then clamped it in vice and worked it down with grandpas #5 and smoothed out final with my T12 5.5. Didnt get picture of the bottom front (underdroopers) but same deal minus the beveling.
sitting on my sawbench
Installed with a bit of glue and some 1 1/4 cut nails, set about 3/16 below surface.
thats it for this installment, next part, tongin’ and a groovin’ and a back.
-- "....put that handsaw to work and make it earn its keep. - summerfi" <==< JuStiN >==>=->