shop jigs/furniture/fixtures #6: tablesaw base revisited

  • Advertise with us
Blog entry by Tugboater78 posted 04-05-2014 04:18 PM 2089 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 5: dust collection for my shop Part 6 of shop jigs/furniture/fixtures series Part 7: wall bench #1 (remove/redesign/rebuild) »

this is where we were:

made some drawers to fit the 2 outer openings, pocketholed and glued together 5/8” ac ply for sides, 3/8” ply for bottoms. used 1/2”x1” oak strips for drawer glides

and after:

when i get center section figured out and my other bench rebuilt with its drawers ill work on making some drawer fronts.

had to take the left stamped wing off due to it not being level and not staying where i put it while trying to adjust it back. Its all good cause im in process of planning a router table of some sort to this side and makes it easier to measure, think, rethink, remeasure, think again, etc.

-- "....put that handsaw to work and make it earn its keep. - summerfi" <==< JuStiN >==>=->

1 comment so far

View Mauricio's profile


7144 posts in 3180 days

#1 posted 04-07-2014 06:28 PM

sweet storage solution man.

-- Mauricio - Woodstock, GA - "Confusion is the Womb of Learning, with utter conviction being it's Tomb" Prof. T.O. Nitsch

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics