LumberJocks

Stanley Miter Box Restoration #2: Rust be Gone

  • Advertise with us
Blog entry by ToddMKS posted 04-18-2013 03:10 PM 719 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 1: The Project Start Part 2 of Stanley Miter Box Restoration series no next part

I have taken the handle off the saw, hit it with a wire brush to remove any loose rust, and coated it with Navel Jelly. This is the first time I have used it and I have to say I like it alot. I have to give the saw one more coat to remove any stubborn rust left. Then I will start wet sanding it. Thanks for looking and please leave a comment with any advice you my have since this is my first saw rehab. Thanks again.



1 comment so far

View racerglen's profile

racerglen

2325 posts in 1469 days


#1 posted 04-18-2013 03:14 PM

Todd, make sure you use a sanding block when you do your sanding, keeps it all flat and if there’s a makers mark, an “etch” under the rust it shouldn’t hurt it..we hope..
;-)

-- Glen, Vernon B.C. Canada

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase