LumberJocks

Stickley desk #3: Joining

  • Advertise with us
Blog entry by TigerTed posted 09-22-2016 03:23 PM 495 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 2: Milling Part 3 of Stickley desk series Part 4: Joining #2 »

Jig used for cutting mortises and groove between mortises. Tried using plow plane but skate interferes. Front of jig registers against reference of workpiece. Router set to 1” deep plows mortises. Have stop blocks which are helpful when it is getting dark.

When cutting mortises, you can see the laminations used to ensure quarter sawn all faces. That was a lot of work. Joint/plane/resaw/joint/glue/joint/plane….

Cut tenons on bandsaw by eye to one surface and then use spacer to ensure tenon width with a tad of clean up stock. Tenons cut dead to width using router plane. Try/fettle/repeat..



1 comment so far

View NormG's profile

NormG

5506 posts in 2467 days


#1 posted 09-25-2016 03:46 AM

Great job

-- Norman - I never never make a mistake, I just change the design.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com