LumberJocks

Wood Table Saw Wing #2: Part 2: The Metal

  • Advertise with us
Blog entry by ThomasLightle posted 01-11-2016 08:38 PM 687 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 1: Preparing and Gluing Up the Wood Part 2 of Wood Table Saw Wing series Part 3: Conclusion »

In part 2 I construct the metal frame that will attach to the table saw fence rails and support the wing. I half/bolted and half/welded some 3/4×3/4×1/8 steel angle to the rails. Then I used some 3/8” hex cap screws as table levelers. Once everything was flat to my liking, I locked it all down from the underside with a couple of drywall screws.

<iframe src=”https://www.youtube.com/embed/8za03qx6nO8” frameborder=”0” height=”315” width=”560”></iframe>

https://www.youtube.com/watch?v=8za03qx6nO8

-- Thom



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com