LumberJocks

Table Saw is home

  • Advertise with us
Blog entry by Rustic posted 2192 days ago 580 reads 0 times favorited 2 comments Add to Favorites Watch

Myh table saw made it home in 1 piece. They had to use heat and brute strength to get it off. Bought a new blade for it, a 60 tooth smooth cut Oldham. I also tested a router relief carving. to see pic go to my projects.

Back to makin sawdust yee haaw.

-- www.carvingandturningsbyrick.com, Rick Kruse, Grand Rapids, MI



2 comments so far

View lew's profile

lew

10002 posts in 2388 days


#1 posted 2192 days ago

Check the bearings for oil/grease leakage. If they heated the blade shaft, the heat could have affected the bearing seals. The bearings are “permanently” lubricated and sealed.

-- Lew- Time traveler. Purveyor of the Universe's finest custom rolling pins.

View tenontim's profile

tenontim

2131 posts in 2377 days


#2 posted 2192 days ago

Congrats. Rick, get yourself a 40 tooth blade for ripping lumber. That 60 will be ok for cross cutting, but it’ll load up with chips if you try cutting any 8/4 stuff. You still will have to go slow even with the thinner stuff.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase