Well today was not a good day. I measured the spot for the 1st dado 3-4 times. Thought that I was dead on. When I went to check it I was at least 1 inch off. Then I realized that I di not take into consideration the bottom piece. The inside dimension is going to be 12 inches. I thought about modifying the design slightly, but that would compromise the whole thing. So tomorrow I am going to start again. I now know the dimensions needed. So now I will make the dado @ 9 inches. I still have 2 fresh sides to use. I can salvage the 2 mistakes and hopefully use them for the top shelving unit or under the window.
Back to the proverbial drawing board!!!!!!! I have pics taken will post tomorrow
Keep the sawdust flying.
-- www.carvingandturningsbyrick.com, Rick Kruse, Grand Rapids, MI
2 comments so far
grizzman
home | projects | blog
7836 posts in 3271 days
#1 posted 01-21-2010 05:33 AM
dont ya just hate that…..at least you can salvage what you did..i know ive never done that kind of mistake :)...good luck tomorrow…...
-- GRIZZMAN ...[''''']
Rustic
home | projects | blog
3253 posts in 3564 days
#2 posted 01-21-2010 03:28 PM
Thanks Grizzman
-- www.carvingandturningsbyrick.com, Rick Kruse, Grand Rapids, MI
Have your say...