LumberJocks

New Outfeed/Assembly Table

  • Advertise with us
Blog entry by Rodzilla12man posted 04-22-2018 03:58 PM 516 reads 0 times favorited 2 comments Add to Favorites Watch

This is the frame for my new Outfeed/Assembly Table for my Grizzly G0691. I’ll be finishing the top today and will post those pics when completed. It is constructed with glue/pocket screws And 16ga Finish nails shot with my finish gun to attach the bottom shelf to the frame, and it’s all done out of 3/4” hybrid MDF/plywood. It’s only a 7 ply with 5 of the 7 being real wood (not sure what species) and the other two being a layer of MDF on either side casing the wood. It seems to be quite stable and it was free which makes me like it that much more! I got 6 sheets of it given to me so I’ve been using it to outfit my shop with some new digs! I’m doing a torsion Box for the tabletop as well as the bottom shelf and where the actual tabletop will rest on the frame and be attached. Dimensions are 76”x33”x35” tall and will rest 1/8” below the tabletop of my saw/extension table. Forgive the unfinished under saw cabinet/storage, that will be next. Anyway, any comments/advice/suggestions are always appreciated! Thanks for looking! GO HAWKS!



2 comments so far

View wrenchhead's profile

wrenchhead

201 posts in 3249 days


#1 posted 04-22-2018 07:49 PM

I think it looks great so far. Might as well build as tough and flat as you can. I use my out feed table as an assembly table a lot of the time so it has to flat (ish).

-- https://www.youtube.com/channel/UCkRuFxW8HhRfyhbTP4SY5UA I could quit if I wanted

View Rodzilla12man's profile

Rodzilla12man

3 posts in 120 days


#2 posted 05-27-2018 10:41 PM

Sorry it took so long to update this project I had an emergency knee surgery take place right after the last post so after sitting in the hospital for a week then recovery/physical therapy sessions I was finally able to get back to work on it and finish it today. I forgot to take photos of the webbing inside of the actual torsion box tabletop but you all know what that looks like anyway. It turned out as good or better than I hoped and sits completely flat which was the whole point of the design and my first project of building kitchen cabinets for a tiny home I’m doing at work will start today! Thanks all for looking and as always, I welcome any comments/suggestions.

-Rod Clousing, Journeyman Capenter/Custom Woodworking Jedi
Meraki Woodworks Northwest
Tacoma, WA

#GoHawks!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com