LumberJocks

Machinist Toolcart #3: Dividers Fittings

  • Advertise with us
Blog entry by PurpLev posted 1158 days ago 1571 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 2: Measure twice, Cut Once, then measure twice again, and cut once more. Part 3 of Machinist Toolcart series Part 4: Gluing up the Carcass »

A small step for this tool cart, a huge step for woodworking…

or not really, but a small step nonetheless.

I was able to dry fit the mitered carcass, and trim the horizontal and vertical drawer dividers to make them fit while keeping everything square (or as close to square as I could manage):

had to leave it like that for the rest of the evening, but was able to sneak back to it for a short while longer and cut a 1/8” slot on all the fronts and backs of all the parts to later use to align the face frames to.

Next step I think would be to glue up the carcass square, and then move on to the face frames.

Thanks for reading,
Peace

-- ㊍ When in doubt - There is no doubt - Go the safer route.



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase