LumberJocks

More tools in the shop #5: Bandsaw scrap box on outfeed

  • Advertise with us
Blog entry by Plasmon360 posted 07-08-2018 06:31 AM 1482 reads 0 times favorited 2 comments Add to Favorites Watch
« Part 4: Bandsaw storage Part 5 of More tools in the shop series Part 6: Designing a Parametric Pencil Box with Sliding Lid in Fusion 360 »

I have a wall behind my grizzly bandsaw and as I cut wood on it (primarily small pieces and such) the scraps fall behind the band saw and it is hard to reach to clean up the mess on the floor. So I built a box that attaches to the the back of the table. I drilled a hole on the cast iron (hopefully this is ok) and made a quick box from scrap pieces and attached at the outfeed of the band saw using piece of steel with holes drilled in it. I made sure the fence can still move back and forth. I am not sure if this will work if the table is tilted, but I am not worried because I rarely tilt my band saw table.

Now all my small scraps go into this box for easy cleanup.



2 comments so far

View Bob Kassmeyer's profile

Bob Kassmeyer

228 posts in 3096 days


#1 posted 07-08-2018 10:20 PM

Nice fix, I hate having to move mine out to clean also. Not that the band saw itself is hard to move just all the junk around it.

-- Bob Kassmeyer, Nebraska

View NormG's profile

NormG

6260 posts in 3174 days


#2 posted 07-15-2018 08:29 PM

Great solution

-- Norman - I never never make a mistake, I just change the design.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com