| This blog is written by Ocelot | 11 entries so far |
-
Equipping the Shop #8: Lumber Racks (and some lumber)
I was eating dinner with my old retired pastor back a few weeks (I think it was in December), whe...
-
Equipping the Shop #7: Harbor Freight 5 Speed Bench Top Wood Lathe - Model #65345
I picked this little lathe up in early december, again with a 20% off coupon and on sale, so I pa...
-
Equipping the Shop #6: Harbor Freight 6-inch Jointer - Model #30289
Probably 3 or 6 months ago, I picked up a little Jointer at Harbor Freight. I had a 20% off cou...
-
Equipping the Shop #5: Tenoning Jig - with add-on digital readout
I had in mind to make a rail and stile sort of thing, with what I think are called box joints in ...
-
Life #3: Baby on the way
My wife, who is in her 40’s, is now 13 weeks pregnant with her first child. God is good ...
-
Equipping the Shop #4: I ordered a bandsaw - Grizly G0513X2
Friday, I finally fired off an order for my bandsaw. All this wood on the ground inspired me. ...
-
Life #2: Tornados
Well folks, there’s a lot of wood on the ground around here. The tornadoes came through ...
-
Equipping the Shop #3: 1950's Craftsman RAS with added crosscut stop rail
Finally, I’ve pulled the photos from my camera. I neglected to photograph it as I bui...
-
Life #1: Life
It’s been 3 weeks since I’ve had opportunity to visit LJ. Some of you who took the t...
-
Equipping the Shop #2: RAS side table with Incra Rail and Stop
Over the past couple of weeks, as I’ve found time, I’ve built a 8-ft side table for t...
-
Equipping the Shop #1: Starting Point
Hi folks! From time to time I’ve read posts on the LJ forum, but this is the first time ...
