LumberJocks

Computer Table #1: Design and Sides

  • Advertise with us
Blog entry by Morton posted 04-29-2010 06:02 AM 1804 reads 0 times favorited 0 comments Add to Favorites Watch
no previous part Part 1 of Computer Table series Part 2: Assembly and Finish »

Computer Table Design building a simple computer table that will house a laptop. The design calls for a wide base and the ability to pull the laptop closer. I’ve used the wide base to have two different surfaces. The left side slides on 12” drawer slides and is slanted for easy viewing and typing on a laptop. The right side is fixed for papers, etc.

The entire piece will be made out of Baltic Birch (or Russian Birch). The final piece will be painted, so the end grain should match (well enough) with the rest of the piece. I’ll use joint connectors to assemble the piece allowing it to be knocked down in the future.

I started by shaping the sides which are the most interesting pieces (the rest are fairly rectangular). I cut some plywood down to outside dimensions and then ganged them up using some brad nails in order to shape both sides at the same time. I traced the shape onto one side and then starting cutting out the lines using a jigsaw and Festool TS55.

While the pieces were still ganged, I sanded them together to give them the same profile (and save time). When they came apart, I had the side in final form ready to go!

Computer Table Side

-- Morton - http://workshop.scottmorton.com



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com