LumberJocks

Cutting Boards #6: Finish Applied

  • Advertise with us
Blog entry by MolokMot posted 821 days ago 3525 reads 1 time favorited 0 comments Add to Favorites Watch
« Part 5: Sanding, routing, sanding... Part 6 of Cutting Boards series no next part

Close to the final step!

The cutting board was sanded down to about 220 grit using an orbital sander.

After sanding the board was cleaned off with mineral spirits.

Finish (50/50 salad bowl finish and mineral spirits) was applied in three coats.
1. Applied a heavy coat till cutting board pulled the finish through to the bottom.
  • Waited 24 hours
    2. Applied a second lighter coat.
  • Waited 24 hours
  • Light sanding with 400 grit.
    3. Applied the third coat

This picture was taken just after the third coat was applied.

**The process was of course TheWoodWhisperer process. Cutting board Video can be found at the link below.

7 – How to Make a Butcher Block End Grain Cutting Board

-- MolokMot, Rocker, Woodworker, Geek



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase