There have been quite a few times that the long list of Wood Working Celebrities have commented on what it takes to become a good wood worker. The one common quote usually goes a little something like this. Stop (watching / reading, ) my (sho...
|View MolokMot's:||home||workshop||projects (18)||blog (8)||reviews (0)||forum topics (6)||buddies (5)||favorites (0)||activity log|
122 posts in 1569 days
Location: Phoenixville, PA
Just getting into wood working, so if I ask alot of questions, bear with me. My experience is primarily turning, however it is time to learn the dark arts of the right angle.
-- MolokMot, Rocker, Woodworker, Geek
Latest Activity | view all »
|commented on||Fun Results...||05-19-2014 04:43 PM|
|commented on||Guitar Hangers||04-29-2014 08:05 PM|
|commented on||Shave Like Your Grandpa||03-17-2014 04:28 PM|
|commented on||Drum Refinishing Project||10-29-2013 01:53 PM|
|added project||Drum Refinishing Project||10-28-2013 08:21 PM|
|commented on||Humidor||09-08-2013 06:30 PM|
|added project||Spalted Wormwood Maple and Walnut Box||06-01-2013 04:57 AM|
|commented on||Cocobolo and Bocote Wine Bottle Stoppers||05-22-2013 08:22 PM|
|commented on||Teak Box with Ambrosia Maple Top||05-22-2013 08:21 PM|
|commented on||Centerpiece Candle Holders||05-22-2013 08:20 PM|
|added project||Centerpiece Candle Holders||05-17-2013 02:13 AM|
|added project||Teak Box with Ambrosia Maple Top||05-17-2013 01:44 AM|
|added project||Cocobolo and Bocote Wine Bottle Stoppers||05-17-2013 01:33 AM|
|commented on||Collaboration||02-08-2013 07:02 PM|
|commented on||Philadelphia Chippendale Stool||02-08-2013 06:24 PM|
Latest Projects | view all 18 »
Latest Blog Entries | view all 8 »
Close to the final step! The cutting board was sanded down to about 220 grit using an orbital sander. After sanding the board was cleaned off with mineral spirits. Finish (50/50 salad bowl finish and mineral spirits) was applied in three c...
The cutting board as seen in the picture below is just about complete. Just needs a little more sanding and finish. Since the last post, here are the steps completed: Using my dewalt random orbit sander I went through both 60 and 100 grit. A...
After the last glue-up, and flattening the panel, I cross cut the panel in strips 1.25” wide. Taking those strips I turned them so the end grain was showing and flipped every other one end for end to create the checkerboard pattern. I am sur...
Each of the strips is milled cut and ripped to the following dimensions: Thickness: Little less than 1” Width: 1.5” Length: 21” There are Five strips each of maple and cherry. I glued up the panel in two sections using an e...