LumberJocks

Jigs and Such #2: Router Insert Modifications

  • Advertise with us
Blog entry by Chris Moellering posted 603 days ago 2056 reads 0 times favorited 2 comments Add to Favorites Watch
« Part 1: PCB220TS Zero Clearance Insert Part 2 of Jigs and Such series Part 3: Getting the Lumber Home »

I have realized that my router insert I made for my table saw could benefit from having a miter slot closer to it, so I decided just to route one into it.

It seemed logical to reinforce the area underneath the slot, since I was taking away half of the 3/4” of plywood and creating a fault line in a piece that supports a motor spinning carbide bits and thousands of rpms seemed less than optimal.

The only drawback is that I don’t have T-slot doing it this way. I don’t see that being a huge drawback at this stage in the game.

-- Grace & peace, Chris+



2 comments so far

View Mark Shymanski's profile

Mark Shymanski

5102 posts in 2348 days


#1 posted 574 days ago

An interesting modification. Does it work well?

-- "Checking for square? What madness is this! The cabinet is square because I will it to be so!" Jeremy Greiner LJ Topic#20953 2011 Feb 2

View Chris Moellering's profile

Chris Moellering

224 posts in 1284 days


#2 posted 573 days ago

So far it has worked fine. I haven’t used it too much, but the couple cuts I’ve done have been good.

-- Grace & peace, Chris+

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase