Mike_D_S's Blog

  • Advertise with us
This blog is written by Mike_D_S | 41 entries so far

Latest Entry

Drill Press Station - Small Shop Challenge #4: basically wrapped up

11-16-2016 02:12 AM by Mike_D_S | 0 comments »

I didn’t take many pictures as I just sort of got in the groove over the last few evenings. I received the new switch for my table saw, so I was back in business end of last week. I cut all the drawer parts and did the joinery. For basic drawer boxes, I like to use a drawer lock bit in my router table. I found a fairly easy way to set the height of the bit, so I can be set up and cutting the joinery in about five minutes. After cutting the joinery for the boxes, I cut a 1/4 dado for the bottoms and glued up all the drawer boxes. While the glue was drying on the drawer boxes, I measured out all the drawer slide heights and cut some 1/4 MDF spacers to position the slides on ...

Read this entry »

Older Entries

View all 41 entries »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics