|Workshop by Mike Gilbert||posted 08-23-2012 at 09:33 PM||1338 reads||0 times favorited||0 comments|
click the marker to see the address
I just moved again, this time to a home in Golden Colorado. Which means starting all over on setting up my shop. So far I have only done a basic layout of where I would like to put my tools and set up the lumber and sheet goods storage. Next I hope to wire in a sub panel and get 220 power to my bigger machines. My new garage is about 700 SF and has lots of space for tools. There is a two car garage door on one side and a one car door on the back side. This lets me open up both side and get good airflow on hot days. The walls and ceiling are insulated and there is a gas powered heater hanging from the back wall so I am hoping I will be able to keep it warm in the winter. Most of my 22o volt tools have been in storage the last 2 years so I have some tuning up to do before I can get any work done. I am starting on my grizzly hybrid tablesaw, the arbor pulley is loose so I have starting attempting a repair. Not really sure what I am doing so it’s going a little slow. I’ll update this page with shop photos when I get a chance.