LumberJocks

Out-feed and dual purpose extension table. #1: Introduction

  • Advertise with us
Blog entry by Mateo posted 09-16-2008 07:01 PM 731 reads 0 times favorited 4 comments Add to Favorites Watch
no previous part Part 1 of Out-feed and dual purpose extension table. series no next part

Hello Lumberjocks,

I have started 2 projects prior to becoming a member. I haven’t got to far. So, I would like to share their progress with the forum.

I have a few projects under my belt, but I consider myself a beginner. So, please, bare with me, the techniques, and the progress.

The projects are an out-feed table and a dual purpose extension table for my Delta 10” contractor table saw.

The extension table with also serve double duty as a router table. It will replace the commercial extension table, that came with the table saw, that has seen better days.

The out-feed table is out of necessity. I learned the second time around that I needed an out-feed table when my sheet goods hit the floor.

The previous home owner was “kind” enough to leave behind his “workbench”. This thing was unstable and unsafe. The good things about it was the top. It was bad of an old heavy solid door. Not solid wood mind you. It was particle based material trimmed in solid wood and veneered. I disassembled the old workbench. I have to admit, I think i pulled something trying to move that old door. Not so much my groin, as it was my pride. LOL. I will be using a good chunk of the door for the out-feed table. Being green, I use a lot of reclaimed materials.

I also plan to user oak to trim the tables. For the legs, I may opt for a less expensive species.

Check back and see the progress.

-- Mateo



4 comments so far

View Scott Wigginton's profile

Scott Wigginton

50 posts in 2396 days


#1 posted 09-17-2008 12:33 AM

Look forward to your progress, both projects are on my eventual to do list when I get some more space for ‘em.

There are some good projects on here from people who’ve done those as well, check’em out and welcome to LJ!

-- Scott

View Steve2's profile

Steve2

75 posts in 2222 days


#2 posted 09-18-2008 06:15 AM

There are of course roller stands to support the ends of lumber behind the saw, also.

-- Regards, Steve2

View Mateo's profile

Mateo

28 posts in 2191 days


#3 posted 09-18-2008 05:34 PM

Yes, there are roller stands. I have them. But let’s face it… an out feed table is far more efficient and effective. I have the room for it. I may as well take advantage of it.

-- Mateo

View sIKE's profile

sIKE

1271 posts in 2405 days


#4 posted 09-18-2008 07:07 PM

Good luck in your endeavors. Looking forward to you many projects.

-- //FC - Round Rock, TX - "Experience is what you get just after you need it"

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase