LumberJocks

How to dimension lumber with handtools #4: Parallel face and edge

  • Advertise with us
Blog entry by LastingBuild posted 09-15-2018 12:20 AM 827 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 3: Reference Edge Part 4 of How to dimension lumber with handtools series Part 5: The infamous crosscut »

After establishing the reference face and edge, I use my marking gauge to mark the board thickness using the reference face as the guide. Once I have marked all four sides, I use my jack plane, jointer plane and smoothing plane to bring down the rough surface of the board to my marking lines. Then, I repeat the step for the board width using the reference edge as the guide. Once finished the board was perfectly square. (as perfect as necessary at least).

If you would like to watch my video tutorial check out this link!

https://www.youtube.com/watch?v=2ptjWgmIMU4

-- LastingBuild



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com