LumberJocks

Mixer stand build #3: Updated drawing, lower shelf and dowel holes

  • Advertise with us
Blog entry by Lalen posted 12-08-2016 08:42 PM 597 reads 1 time favorited 0 comments Add to Favorites Watch
« Part 2: Legs and "joinery" Part 3 of Mixer stand build series Part 4: Getting it finished - Almost »

Updated drawing- Planning to use walnut for contrasting dowels. Stain will be early american, a bit lighter than this indicates.

Planing the lower shelf with the router jig. Much easier with a 1.5” bit! I didnt think about it while setting it up, but by making the side rails sacrificial and tight to the piece it gives a good zero clearance to avoid tear out.. Not a problem on the ends because they will be cut off square.


Installing the lower shelf.

Using table saw top, clamp, guide block and painters tape depth stop to get precise dowel holes.

Next up.
1. installing dowels
2. Making the towel bar and installing
3. Sand and finish.

-- Lalen, Texas. "If it looks straight, it is straight" Jimmy Diresta



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com