LumberJocks

Building an end table #3: mortising the legs

  • Advertise with us
Blog entry by Julian posted 09-04-2012 04:45 AM 3727 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 2: Sketch Part 3 of Building an end table series no next part

Finally had most of a day to make a start on the end table. Purchased some thick African mahogany for the legs. Milled the legs down to size (1 3/4” square x 23 3/4” L). Routed the bottoms with a 1/4” round over bit on the router table. Then used the mortising jig to cut 15 mortise holes (1/4” x 5”L).

-- Julian



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase