I am in the process of building another side gate for the house. I had two rails that were 55” long.Too long to fit in the mortising jig which I normally clamp to the workbench. I needed to raise the mortising jig approximately...
|View Julian's:||home||workshop||projects (18)||blog (8)||reviews (3)||forum topics (7)||buddies (0)||favorites (168)||activity log|
None so far
653 posts in 1628 days
Location: Rancho Cucamonga, CA
Woodworking for ~30yrs as a hobby. Want to elevate my skills in order to build 18th century reproductions.
Latest Activity | view all »
|started topic||Perfectly cut segments the first time||06-27-2015 01:55 AM|
|posted review||Freud router bit broke into 3 pieces.||06-25-2015 10:06 PM|
|replied on||Whiteside router bits||06-25-2015 08:56 PM|
|commented on||воин||06-24-2015 02:32 PM|
|commented on||Fire Engine Bed||06-22-2015 02:52 PM|
|commented on||Love Birds - Marquetry||06-18-2015 05:06 PM|
|replied on||Delta Rockwell Lathe - Is this a good buy||06-18-2015 03:28 PM|
|commented on||The USA is only one of three countries which don't approve of metrication||06-18-2015 03:13 PM|
|replied on||Miter saw questions||06-16-2015 03:05 PM|
|replied on||Just ordered an Infinity 40T Super General table saw blade to replace an aging Forrest Woodworker II||06-16-2015 02:52 PM|
|replied on||delta x5 shaper||06-11-2015 02:40 PM|
|commented on||Vines||06-10-2015 02:06 PM|
|replied on||SawStop PCS w/ 36 inch T-Glide fence package *SOLD*||06-04-2015 10:15 PM|
|commented on||Swirl Bowl||05-26-2015 02:21 PM|
|commented on||Benchtop Bench||05-21-2015 02:22 PM|
Latest Projects | view all 18 »
Latest Blog Entries | view all 8 »
I made this simple veneer press in preparation for a project. The veneer press is similar to a couple I saw posted here on L.J. I don’t have any spare room left in the garage so I wanted a veneer press that could be easily disassem...
Finally had most of a day to make a start on the end table. Purchased some thick African mahogany for the legs. Milled the legs down to size (1 3/4” square x 23 3/4” L). Routed the bottoms with a 1/4” round over bit on the...