| This blog is written by JohninSD | 19 entries so far |
-
Kayak Hanger #1: Boat storage in a too small garage
I have 2 home built sea kayaks, one a Chesapeake 17 which is 17 feet long by 24” wide and t...
-
Circle Cutting Jig for a Saber Saw #1: Quick and Easy Attachment for a Ryobi
I had occasion to need 5 23” diameter circular pieces of plywood for some garden planters. ...
-
Tablesaw Workstation #16: New casters from Woodcraft - much easier rolling.
I bought the Woodriver leveling casters from Woodcraft when they were on sale for $80 a week or s...
-
Tablesaw Workstation #15: Well it's been a while
Got busy with a few other things but I’ve finally got back to putting the finishing touches...
-
Tablesaw Workstation #14: Thanksgiving's over - back to work (so to speak)
It’s not really “back to work” since I’m retired and doing this because I...
-
Tablesaw Workstation #13: The End is in Sight (I Think)
Today I’ve finished fitting the tops to the workstation – they’re not screwed d...
-
Tablesaw Workstation #12: Danger - I may actually finish this thing
These last two days have been eventful. Got the laminate glued onto the tops and got the aluminu...
-
Tablesaw Workstation #11: New Toy and Rough Cutting the Laminate
It’s getting close to time to apply the laminate to the top blanks. I had purchased a 4...
-
Tablesaw Workstation #10: Back at it
The house is now termite free (I hope), after the exterminating company put up a giant tent over ...
-
Tablesaw Workstation #9: Slow Going Lately
Well no progress to speak of for the past several days. I got distracted when I found a bunch of ...
-
Tablesaw Workstation #8: One Side of Top Almost ready for Formica
Took the clamps off yesterday’s glue up and routed the edge banding flush with the MDF. The...
-
Tablesaw Workstation #7: Working on the Tops
Today’s progress consisted of trimming the tops to correct dimensions. I’d left them ...
-
Tablesaw Workstation #6: Drawers completed and installed
A little more progress – finished assembling the drawers yesterday and installed them today...
-
Tablesaw Workstation #5: Some progress on the drawers and tops
Made a little more progress – building the drawers, squaring up the tops. This workstation ...
-
Tablesaw Workstation #4: Straightedge guide not straight????
An interesting thing happened this morning in the shop. The straight cutting guide I made yesterd...
-
Tablesaw Workstation #3: Squaring Up the Tops
I glued up oversize blanks for the two halves of the new top. I did the right hand one with fir p...
-
Tablesaw Workstation #2: A little more progress
No pictures today. All I got done was gluing together two pieces of fir plywood for the right han...
-
Tablesaw Workstation #1: A little more progress
Today I made the 3 doors for the front of the workstation. They’re simple doors, just 3/4&#...
-
From plansnow.com plan
I stumbled onto Lumberjocks while looking for inspiration to build a Tablesaw Workstation, somet...
