LumberJocks

Ambrosia-birdseye maple #2: Pieces milled and cut

  • Advertise with us
Blog entry by JoeyG posted 11-17-2011 01:15 AM 1399 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 1: The Boards Part 2 of Ambrosia-birdseye maple series Part 3: Bottom Detail »

So here is the next phase in the early life of a box.

After straight lining one of the boards and cutting to a rough length for my project, I split the board in half. I usually go for 3/8 or a little larger but since these boards were already surfaced I couldn’t make them thicker. LOL. I ended up a little proud of 5/16 thick. I know a lot of people make there boxes 3/4 thick but this way works better for me. I will add to the interior once the lid is sized and everything is together. Trust me. It sounds wacked but as I said, it works for me.

After splitting the board and planing, I pull out the old miter sled and set the table saw to 45 degrees and cut the pieces to size. Set stop is designing and cutting the bottom detail. I’ll post once I get it done.

Thanks for following along on this journey.

-- JoeyG ~~~ http://www.facebook.com/JHGWoodWorks



1 comment so far

View JoeyG's profile

JoeyG

1248 posts in 1292 days


#1 posted 11-17-2011 01:16 AM

It’s not a very good picture, but I am sure you get the idea.

-- JoeyG ~~~ http://www.facebook.com/JHGWoodWorks

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase