Burr Cleaning Method
To begin, this is not my idea but I have adopted it as a very useful way to clean Dremel burs and similar type rotory bits.I began by turning a piece of 1”X1” plastic material (just somthing I had) wood also works fine. As the pictures show. I then drilled a 1/2” hole leaving about 1/2” from the end …. do not drill completely threw it.Then I bought a Dremel brass brush and put a slight crimp at the end of the shaft about 1” from the brush.I then drilled a hole that is slightly bigger than the bit shaft into the oppisite end of the plastic handle.Push the brush bit into the plastic/wood handle. Run the tool on high speed and place brush against the bi...
