LumberJocks

JSOvens's Blog

  • Advertise with us
This blog is written by JSOvens | 14 entries so far

Latest Entry

Kitchen Utensil Box #2: Milling the components

05-19-2015 06:16 AM by JSOvens | 0 comments »

Hello again, I left off last time with the design and materials for the kitchen utensil box. I started by milling the Padauk for the four corner posts. These posts are 1” square, while the piece of Padauk I purchased is 8/4. To avoid excess waste, I decided to resaw off about 5/8” for later use. I primarily used my table saw with a thin kerf blade, but since the board was about 6” wide, and my max blade height is 2”, I had to complete the operation by hand. Below is what I ended up with. Since I did not own a hand rip saw, I purchased the least expensive “decent” one I could find: the Pax from Lee Valley. I worked just fine for a hand saw novi...

Read this entry »

Older Entries

View all 14 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com