161 days ago
by Craftsman on the lake |
13 comments »
This was a simple coffee table with drawer made with about $20 in materials and spanning three afternoons. My daughter wanted something that she could move easily from apartments and maybe even leave behind when she finishes her post docterate in boston. She is a research fellow at Beth Israel Hospital
This afternoon, I cut out the legs, planed and rough sanded everything, Routed ogees on edges, assembled the legs to the table and installed the drawer with the drawer slides.
My daughter...
Read this entry »
1382 days ago
by degoose |
40 comments »
Hi guys ,, I had a request to make a tutorial with regards the endgrain Tumbling Block Design.First off,.., You need to decide the size of the blocks…. for this example I used 1” stock… Or something similar.. actually just over .. once dressed.
Set the blade of the table saw to 60 degrees.. a bevel box makes this simpleI use the INCRA fence system so it is easy to rip bevels off side of the blade.Once the bevels are ripped measure the length of the bevel and move the f...
Read this entry »
1354 days ago
by poroskywood |
34 comments »
Hey everybody, after a few personal messages here is my version of a how to on a Drunken Checker Board. I of coarse bow to the Chairman of the Board and pay tribute with beer. This is a Off-Checker pattern I call “Drunken Alice in Wonderland” The “serendipitous” nature of this piece is appealing in a far out sort of way. Here Goes…
So first I prepare the Material. I am using Hard Maple and Walnut both are surfaced flat and cut 1” x 9” x 14&...
Read this entry »
